So there I was preping the Blushing Porker for the Augrabies run, when horror of horrors ......I notice an oil mark under the final drive Ahhh shit ....final drive bearing about to fail. Off with the rubber boot and about half a litre of oil pours out
Dammm ...this dosent look good. Drained the FD and the correct amount of oil came out...so I figured that the oil didnt come from there. Drained the gearbox and only about half a litre poured out so I guess the gearbox output shaft seal must be leaking.
Anyways I whipped off the swing arm and drive shaft and there is oil in the upper boot as well. so I guess that confirms the output shaft seal leaking. So the question is ....what is the best way to remove that seal without removing the gearbox :-\
Dammm ...this dosent look good. Drained the FD and the correct amount of oil came out...so I figured that the oil didnt come from there. Drained the gearbox and only about half a litre poured out so I guess the gearbox output shaft seal must be leaking.
Anyways I whipped off the swing arm and drive shaft and there is oil in the upper boot as well. so I guess that confirms the output shaft seal leaking. So the question is ....what is the best way to remove that seal without removing the gearbox :-\