Is there a brass insert cast in the tank for the bolt to go into or is it a type of self tapping screw? Permatex makes a fuel proof type of gasket maker silicone that i have used to replace the o ring seal on my Acerbis tank where the fuel tap screws in. just mentioning , it may give you some...
What size tamper proof torx bit is the ignition bolts? T40?
Will heat them up to loosen the lock tite that sticks like stink to a turd but dont have a set of those bits so want to buy correct size to get the bastard out!
Ignition contacts are losing contact causing bike to suddenly die...
weld a thick washer to the outside of worn holes, allowing the bolts will be long enough. or drill out to size of washer and weld into hole.
Can also weld solid piece into hole and drill, just dont quench the weld will be hell to drill also weakens weld.....
The flat surface on the shaft should be facing towards the inside of casing and there should be tension on spring when in that position. The rod that fits thrust bearing will hold it in correct position when casing is fitted.
But then again the casing should not fit properly if round part of...
2 up on the DR can be done at 110 to120 cruizing speed exept fokol dikgat pillions and very little luggage!
Yes i am a maergat therefor i have a DR instead of big bike.....a well set up DR with the right aftermarket goodies will outlast an XRL when logging 500+ kilos a day...i have taken that...
Pushrod motor same as Xr125 and old Honda CG 125 . Most of the chinese bikes have same motors from 125 to 200 cc. Spare parts are dirt cheap and piss easy to fix. If properly rebuilt or run in those motors are bullet proof...
Shit! you were damn lucky! could have ended up real bad! The rigger that gave that lift the ok should also be fired, well looking at the way that they lifted that bundle no capable rigger involved anyway!
eish!!!!