Clockwork Orange
Race Dog
- Joined
- May 22, 2006
- Messages
- 2,768
- Reaction score
- 105
- Location
- United Kingdom
- Bike
- KTM 990 Adventure
I need to get a good base setup going for the jetting and needle position for the carbs on my 950 adv.
Taking into consideration that I run the standard setup with the paper filter and original snorkel (no pre filter)
I have Akro cans on the bike.
What is the standard reccommended jetting for this configuration
What needle clip position is best.
The reason I ask is that I have the carbs out and will be sending it in for ultrasonic cleaning. I t makes sense to check that my setup is correct while doing this. I find that my bike pops a lot on deceleration. I believe that this is an indication of running too lean.
I am preety clueless with the workings of a carb so your advise will be greatly appreciated.
Taking into consideration that I run the standard setup with the paper filter and original snorkel (no pre filter)
I have Akro cans on the bike.
What is the standard reccommended jetting for this configuration
What needle clip position is best.
The reason I ask is that I have the carbs out and will be sending it in for ultrasonic cleaning. I t makes sense to check that my setup is correct while doing this. I find that my bike pops a lot on deceleration. I believe that this is an indication of running too lean.
I am preety clueless with the workings of a carb so your advise will be greatly appreciated.