Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jughead's latest activity
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Jughead
replied to the thread
Frankenstein
.
I make those knoppies out of aluminum, so they never break off again. The little piepie below the circlip normally breaks off, then...
Jul 4, 2024
Jughead
replied to the thread
A day in the workshop ...
.
👍
Jul 3, 2024
Jughead
replied to the thread
A day in the workshop ...
.
Yes, the 1150 has the same top. Just the bottom end needs an adapter.
Jul 3, 2024
Jughead
replied to the thread
A day in the workshop ...
.
If there is enough interest I would possibly be prepared to turn out say 10 sets. Will have to give some thought to costing, but it...
Jul 2, 2024
Jughead
replied to the thread
A day in the workshop ...
.
I didn't intend to, but can make more if there are more guys that want. Bit of a hassle making only one set at a time.
Jul 2, 2024
Jughead
replied to the thread
Frame welding
.
Oh, and tig weld it if you can
Jun 30, 2024
Jughead
replied to the thread
Frame welding
.
Put the earth clamp as close as you can, if not directly next to where you intend to weld. I have never removed the battery or...
Jun 29, 2024
Jughead
replied to the thread
1100 GS Service, 120000 km
.
Clutch on the 1100 is cable operated, not hydraulic like the 1150/1200.
Jun 29, 2024
Jughead
replied to the thread
A day in the workshop ...
.
Correct @Beebop, The o-ring is imbedded in the hole in the throttle body and stays in place when removing the injector.
Jun 29, 2024
Jughead
replied to the thread
A day in the workshop ...
.
I haven't investigated that yet, but will have a look at the 1150 setup when I get one in again.
Jun 28, 2024
Jughead
replied to the thread
A day in the workshop ...
.
Thanks Mikie! 👍
Jun 28, 2024
Jughead
replied to the thread
A day in the workshop ...
.
All parts are back and ready to be assembled. Old parts on the left, new on the right.
Jun 28, 2024
Jughead
replied to the thread
A day in the workshop ...
.
Correct OomD
Jun 26, 2024
Jughead
replied to the thread
A day in the workshop ...
.
:ROFLMAO: Fortunately on the GS it sits on the outside.
Jun 26, 2024
Jughead
replied to the thread
A day in the workshop ...
.
All done and on the way to be anodised. Will get the retaining plates from the laser cutters first thing tomorrow.
Jun 26, 2024
Members
Top