This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Jughead
Reaction score
643

Latest activity Postings About

    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      Awesome. My only concern with the plastic 3D printed one is it holding up to the 65Nm tightening torque of the cam gear. But at least...
    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      Cam Alignment tool if you have a 3d printer. https://www.thingiverse.com/thing:5413716
    • Jughead
      Jughead reacted to AntVan's post in the thread Resurrecting Hildr with Like Like.
      That is an excellent trick! Thank you
    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      Here's a trick for the expanding rivet that I use. Use a 2mm ball-end Allen key at a 45⁰ angle to push the pin in. The ball-end will...
    • Jughead
      Jughead replied to the thread Replacement cables make up.
      I have not had good experiences with Cableman replacements. Lengths are not always exactly what they should be, and quality is a little...
    • Jughead
      Jughead replied to the thread Clutch adjustment, 1200 AC?.
      Perfect. I would watch the level though. If it drops AT ALL, have the clave cylinder checked out.
    • Jughead
      Jughead replied to the thread Clutch adjustment, 1200 AC?.
      My guess would be that the slave cylinder is moertoe. Take it off, inspect/replace before all the fluid end up on the clutch. I hope...
    • Jughead
      Jughead replied to the thread Booster Plug.
      The constraints being the EU emission control standards, which force (some) manufacturers to constantly make the mixture leaner and...
      • 20230820_123133 (1).jpg
    • Jughead
      Jughead replied to the thread Booster Plug.
      FAR better to have the bike remapped properly, instead of some aftermarket gadget that may or may not try to fool the ECU into believing...
    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      There is no need to mark the sprocket/gear teeth or cable tie the chain to the big sprocket. Timing is VERY easy to set up. Assemble...
    • Jughead
      Jughead replied to the thread A day in the workshop ....
      That's easy to resolve. You just take ⅓ of the total amount required in each viscosity, mix them all together, and Bob's your uncle. 🤣
    • Jughead
      Jughead replied to the thread A day in the workshop ....
      I had a youngster (probably 18) come to me earlier in the week. He and his dad have been trying to sort out his EX250 Ninja that has...
    • Jughead
      Spuit al jou bedrading hiermee...
    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      Agree 100%
    • Jughead
      Jughead replied to the thread Resurrecting Hildr.
      You can remove the entire head without dropping the motor out of the frame. What I see in the pics is an easy fix. Shouldn't take more...
  • Loading…
  • Loading…
Top