Hi to All,
Bike is a 2006 gs1200 adv with 140000 kilos on clock.
About 3 months ago the fuel pump controller failed. That was replaced and the bike ran fine.
As the plastic panels was already off and the bike needed some TLC I decided to fix some things on it and then reassemble it.
It stood for about 3 months while replacing / rebuilding windscreen, headlight, brake discs, shocks etc.
Yesterday the bike is assembled again. It starts instantly and runs fine.
I push it outside and wash it with a high pressure washer.
AND IT REFUSE TO START!!!
There's spark but no fuel pressure.
Pull the fuel pressure controller plugs and they are bone dry, but there's no current on the connector
wires.
Where must I go from here?
Help please!
Bike is a 2006 gs1200 adv with 140000 kilos on clock.
About 3 months ago the fuel pump controller failed. That was replaced and the bike ran fine.
As the plastic panels was already off and the bike needed some TLC I decided to fix some things on it and then reassemble it.
It stood for about 3 months while replacing / rebuilding windscreen, headlight, brake discs, shocks etc.
Yesterday the bike is assembled again. It starts instantly and runs fine.
I push it outside and wash it with a high pressure washer.
AND IT REFUSE TO START!!!
There's spark but no fuel pressure.
Pull the fuel pressure controller plugs and they are bone dry, but there's no current on the connector
wires.
Where must I go from here?
Help please!