Hi Folks
I bought a set of Rox bar risers for my GSA 1200 - 2006.
They made to fit a bar diameter of 1 1/8, when fitting them I found that the two rear bolts were impossible to tighten to the correct torque because the bar riser and the original handlebar clamp are too close to each other and I cannot get a spanner in the space to tighten.
Has anyone fitted similar and how did you overcome the problem ???
I bought a set of Rox bar risers for my GSA 1200 - 2006.
They made to fit a bar diameter of 1 1/8, when fitting them I found that the two rear bolts were impossible to tighten to the correct torque because the bar riser and the original handlebar clamp are too close to each other and I cannot get a spanner in the space to tighten.
Has anyone fitted similar and how did you overcome the problem ???
