Jughead's latest activity

Awesome. My only concern with the plastic 3D printed one is it holding up to the 65Nm tightening torque of the cam gear. But at least...

Cam Alignment tool if you have a 3d printer. https://www.thingiverse.com/thing:5413716

That is an excellent trick! Thank you

Here's a trick for the expanding rivet that I use. Use a 2mm ball-end Allen key at a 45⁰ angle to push the pin in. The ball-end will...

I have not had good experiences with Cableman replacements. Lengths are not always exactly what they should be, and quality is a little...

Perfect. I would watch the level though. If it drops AT ALL, have the clave cylinder checked out.

My guess would be that the slave cylinder is moertoe. Take it off, inspect/replace before all the fluid end up on the clutch. I hope...

The constraints being the EU emission control standards, which force (some) manufacturers to constantly make the mixture leaner and...

FAR better to have the bike remapped properly, instead of some aftermarket gadget that may or may not try to fool the ECU into believing...