Jughead's latest activity
-
Jughead replied to the thread F650GS clutch mutch @#%#?.Yup, clutch and,as Rob says, DIY it. You will most likely only need the friction plates. Also, check the freeplay on the clutch lever... -
Jughead replied to the thread A day in the workshop ....Yup, that's the one.
-
Jughead replied to the thread A day in the workshop ....And here is the actual reason the 1150 came in. Caught this one just in time before it destroyed the casing as well.
-
-
Jughead replied to the thread Husky Norden Starting hassle.Remove and service the starter. Check to make sure none are the windings are dead or shorted. Fit new brushes if they are more than ½...
-
Jughead replied to the thread A day in the workshop ....So the tap works really well. Very pleased with it. It cleaned up and repaired the majority of the damage. There are about 2 turns of...
-
-
Jughead reacted to Exploratio's post in the thread Metalworking, machining and welding DIY with
Like.
Just wow. Well done and good thinking outside the box. Hell, 'mlungus are clever -
-
Ja, I remember when I was still 'on the bench' our machinists used to regard EN36 as an almost holy grail type metal. That is flippin...
-
I am in awe!!!! Your skills never cease to amaze me.
-
Jughead replied to the thread Metalworking, machining and welding DIY.I had a little oops with an R1150GS gearbox I was removing from the bike. The RHS swingarm pivot went thread bound and damaged the...
-
-
Even me....!
-
A great solution to the problem, nicely done!!
-
Jughead replied to the thread A day in the workshop ....I love turning EN36. Using the correct tool, speed and feed can give you an almost chrome looking finish.
-
Jughead replied to the thread A day in the workshop ....:ROFLMAO::ROFLMAO: Yes, I could have made a new insert from scratch, but I already had one inside the old buggered pivot. I just had to...
-
Jughead replied to the thread A day in the workshop ....So this little screw-up required that I make a new tool. Sigh! ;) Started off with a nice chunk of EN36, turned down to the correct...
-
