Hi guys,
I have been reading up on some of the older posts and came across a device called the Accelerator Module. I need to sort out my bikes stalling issues and was wondering if this might be the solution I require?
The bikes idles fine but will occasionally stall out when pulling away in 1st gear or if I ride at slow speeds in a higher gear and try and open the throttle a bit. This is really driving me up the wall as stalling out in peak traffic is not my idea of enjoyable riding. :cussing:
I have also read that the following might help:
Vortex ECU - a bit expensive
mapping - Not sure what mapping is loaded, my bike has got an FMF pipe and idles fine.
Throttle calibration - done
Idle reset procedure - done
Throttle sensor check/adjustment - not done
Idle CO check/adjustment - not done
Any advise would be appreciated. :thumleft:
I have been reading up on some of the older posts and came across a device called the Accelerator Module. I need to sort out my bikes stalling issues and was wondering if this might be the solution I require?
The bikes idles fine but will occasionally stall out when pulling away in 1st gear or if I ride at slow speeds in a higher gear and try and open the throttle a bit. This is really driving me up the wall as stalling out in peak traffic is not my idea of enjoyable riding. :cussing:
I have also read that the following might help:
Vortex ECU - a bit expensive
mapping - Not sure what mapping is loaded, my bike has got an FMF pipe and idles fine.
Throttle calibration - done
Idle reset procedure - done
Throttle sensor check/adjustment - not done
Idle CO check/adjustment - not done
Any advise would be appreciated. :thumleft: