Inprogress
Race Dog
- Joined
- Jun 17, 2008
- Messages
- 1,297
- Reaction score
- 0
- Location
- Port Elizabeth - The friendly city
- Bike
- NER-A-CAR
Allo dogs.
I need a few pieces of square tubing milled down, all four sides with a ridge in the middle. I only need 8 of them though and I'd like to have them before the 5th of December.
I did a quick sketchup last night, its 25mm square tubing, mild-steel. I'd prefer aluminum just for the little weight savings, not sure about strength though unless I go higher grade aluminum with will increase the cost quite a bit I think.
Anyone available for this? If I had my own small milling machine I would do it myself, but alas earwax.
The two images show the square tubing, and what I want to mill down.
I need a few pieces of square tubing milled down, all four sides with a ridge in the middle. I only need 8 of them though and I'd like to have them before the 5th of December.
I did a quick sketchup last night, its 25mm square tubing, mild-steel. I'd prefer aluminum just for the little weight savings, not sure about strength though unless I go higher grade aluminum with will increase the cost quite a bit I think.
Anyone available for this? If I had my own small milling machine I would do it myself, but alas earwax.
The two images show the square tubing, and what I want to mill down.
